1
General Gaming / RE: please insert coin...
« on: October 10, 2004, 06:45:33 PM »
I think it took around 20 minutes to figure out what kind of bit to use, then how to use it. It takes a screw or two to get used to how to do it, after that... well, you're already halfway done ^_^;
Once you get those tamper proof screws off, you'll be able to lift off the cover, then pop off the front face plate. After that, it's just a little pop to get the memory card flap to snap off, then you're in business.
If you don't have the right bit, or can't find one... you could grind a standard (the flat head) bit to have a small divot in it. Try to make it around 10 to 15 mm wide. I think. o_o; About the size of the N in nintendo on the bottom of the GC (the one inside the oval).
Once you get those tamper proof screws off, you'll be able to lift off the cover, then pop off the front face plate. After that, it's just a little pop to get the memory card flap to snap off, then you're in business.
If you don't have the right bit, or can't find one... you could grind a standard (the flat head) bit to have a small divot in it. Try to make it around 10 to 15 mm wide. I think. o_o; About the size of the N in nintendo on the bottom of the GC (the one inside the oval).